Fiessler RAZL-2, Manual

Page: 61 / 161

External actuators
You have the possibility to control external WLAN-enabled relays with the RAZL-2 CO. Connect to the RAZL-2 CO
main column and activate the configuration mode. In the menu, open the
External Actuators entry. Here you can see an
overview of the actors that are ready to be connected to the system. Each actuator displays the name and the most
recently sent command. If a - is displayed instead of the command, the configured timeout for actuators has been
exceeded.
Add a new actuator
The actuator must be a participant in the RAZL-2 CO network. The ip range allowed for external devices is 10.1.10.2 -
10.1.10.99. Information from the system can be transmitted to the actuator via placeholders in the Url or the POST
request content.
l
Number of guests: {CURRENT_GUESTS}
l
System Status: {SYSTEM STATUS}
l
Result of the event rule: {CONDITION-RESULT}
Press the
Add New Actuator
button. A configuration interface opens with the following properties.
Name Custom name of the actuator
Event type Select the event in which to address the actuator.
Event Select the status of the event. For example, for the event type 'Number of persons
changed' is either 'Increasing number of persons' or 'Falling number of persons'
Url of the actuator Enter the url of the actuator. You can use wildcards in this field. Example of a url with a
Shelly PM1 relay: http://10.1.10.2/relay/0?turn={CONDITION-RESULT}
Request Header 'Con-
tent-Type' The default value of 'application/json; charset=utf-8' for the content type usually does
not need to be changed.
HTTP request method Choose the required request method POST or GET. For a Shelly relay, select GET.
HTTP Post Request Con-
tent This field is only available with the CASE method POST. The content depends on the
device. You can use wildcards in this field.
Event Rule Select whether the actuator should only be addressed when the event type and event
have occurred, or whether the actuator should also be addressed if another event has
occurred.