FieldServer BACnet, Startup Manual

Page: 8 / 14

BACnet Router Start-up Guide Page 8 of 14
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
6 CONFIGURING THE BACNET ROUTER
6.1 Settings
6.1.1 Button functions

Save - write the currently displayed settings to the device. A restart will be required to
apply the updated settings.

Reload - discard the currently displayed settings and reload the settings stored on the
device. This will undo any unsaved edits.

Defaults - discard the currently displayed settings and load default settings. This must
still be saved and the device must be restarted for the default settings to be applied.

Restart - restarts the device.
6.1.2 Network Settings
The IP settings for the Router are also used by both BACnet/IP
connections. The IP settings can be changed in the Network Settings
section as shown.
6.1.3 All connections

Network Number - set up the BACnet network number for the connection. Legal values are 1-65534. Each
network number must be unique across the entire BACnet internetwork.

Enable - enable or disable the connection; note that BACnet/IP Primary is always enabled.
6.1.4 BACnet IP Primary

Device Instance and Device Name - A BACnet Router must
provide a Device Object. Configure its name and Instance Number
here. Take care to select a Device Instance Number that is unique
across the entire BACnet internetwork.

IP Port - the BACnet/IP default is 47808 (0xBAC0), but a
different port number may be specified here.