19
18
Primary Air
Primary air temperature is measured during startup and is used for
the COMBUSTION test. This is the temperature of the air going into the
combustion equipment. It’s sometimes useful to set it after startup if
the ambient temperature changes. You can enter it manually or use the
probe’s temperature sensor.
Read “Safety Information” section.
1. Ensure startup is complete.
See “Powering On” section.
2. Select PRIMARY AIR from the JOB MENU.
3. Move the probe to the entry point of air into the combustion
equipment.
4. View live measurement or use the keyboard onscreen to
manually enter a value.
5. SAVE the temperature.
“DELETE” temporarily deletes a single value so you can retest.
“DELETE TEST” deletes the test.
Smoke
The smoke test is used to document the soot levels within the flue.
This is good practice when “dirty” combustion is expected in order to
extend the life of CAT45 and equipment. A third party smoke tester is
needed.
Read “Safety Information” section.
1. Ensure startup is complete.
See “Powering On” section.
2. Select SMOKE from the JOB MENU.
3. Use your smoke tester to find the smoke level.
4. Select the corresponding level on screen.
5. SAVE the smoke level.
“DELETE” deletes the entry.
Customer
Each job has a customer entry. JOB ARCHIVE uses this entry for
searching. You can use this field for whatever you want. For example,
it can be a serial number or a phone number. See “Settings” section for
report contents.
1. Ensure startup is complete.
See “Powering On” section.
2. Select CUSTOMER from the JOB MENU.
3. Use the keyboard to enter.
4. SAVE the customer.
“DELETE” deletes the entry.
Note
Each job has a note entry.
1. Ensure startup is complete.
See “Powering On” section.
2. Select NOTE from the JOB MENU.
3. Use the keyboard to enter.
4. SAVE the note.
“DELETE” deletes the entry.
