FZS 4003-B
14
EN
Instructions for use | Maintenance and storage
Safety instructions
Cutting tools
When mounting the cutting tool, check the blade condition. If it is damaged (cracked, bent,
abrupt etc.), eplace it.
After having installed the blade, check whether the hole in the blade is aligned with the arm of
the blade carrier.
Rotate the blade, check whether the blade does not tend to rotate irregularly.
Be sure to install the blade with its cutting edge in the direction of rotation. Never mount it the
other way around.
Check whether the cutting tool has been assembled properly, rotate it without a load
(1 minute is enough).
The blade has to be chosen appropriately for the given material.
Never push the blade against objects while working. Objects must be cut at mild speed.
If you hear an unusual sound or the machine vibrates unusually while working, stop working
and find-out the cause.
Do not stop the machine while the blade is going through the cut object. There is an injury and
machine damage danger.
The cutting tool must be fitted with an appropriate protective cover.
WARNING!
The failure to follow instructions may result in serious or fatal
injury of persons!!
Give all persons working with this machine information on the machine operation and safety
instructions.
7. MAINTENANCE AND STORAGE
Machine maintenance
Before each use:
- Recheck tightening of all screws, bolts and nuts.
- Check whether fuel is not escaping from the fuel tank.
After every 20 hours of operation:
- Clean the air cleaner (1) (see Fig. 11).
- Clean the fuel filter.
After every 50 hours of operation:
- Clean the spark plug and adjust a gap between electrodes to 0.6 - 0.7 mm distance
(see Fig.12).
- Clean deposits from the exhaust pipe and the muffler.
- Dismount the shaft and lubricate with quality lubricant.
