Fieldmann FZR 2045 E, User Manual, Page: 12 / 84

EN 12 Operation
FZR 2045-E
6. OPERATION
6.1 SETTING THE MOWING HEIGHT
! Before setting the mowing height, always make sure that the lawn mower is turned off and the blade is not
moving.
ATTENTION
: The blade will rotate for several seconds after the lawn mower is turned off. A rotating blade
can cause injuries.
The lawnmower has central mowing height adjustment with 6 settings from
20 - 70 mm.
Select the mowing height by moving the lever to the required position. (push
the lever outwards, move it to the correct position, push inwards to fasten it. See
Fig. 13.
Note: Lawns of standard grass blends should not be mowed to less than 4 cm.
Lawns should not be cut by more than 1/3 of their height.
6.2 SETTING THE HANDLE HEIGHT
The handle height can be set to your needs.
Release the clamping levers (15) on both sides of the bottom part of the handle (8).
Set the required height of the handle by moving it up or down. Then secure with the quick clamping levers.
6.3 CONNECTING TO THE ELECTRICITY.
Insert the power cable plug into the power grid (230-240 V, 50 Hz).
Check that there is enough power cable available.
6.4 TURNING THE LAWN MOWER ON/OFF
6.2.1 Turning it on:
Press and hold the safety button, see Fig. 14, point 1, pull the switch lever to the
handle, see Fig. 13, point 2. Release the safety button.
6.2.2 Turning it off :
Release the switching lever, see Fig. 13, point 2
ATTENTION
: The blade will rotate for several seconds after the lawn
mower is turned off.
ATTENTION
: Do not turn the lawn mower off and on in quick
succession.
PIC. 13
PIC. 14