Fieldmann FZR 2040-E, User Manual, Page: 15 / 18

EN
ELECTRIC LAWNMOWER USER'S MANUAL
15
Maintenance
8. MAINTENANCE
ATTENTION!
Before proceeding to remove the grass catcher, always turn off the lawnmower and pull the
plug on the extension cord out of the power socket.
Note:
We recommend that you regularly perform the maintenance described below, this will increase the
lifetime of the machine and increase its reliability.
Regularly visually inspect the machine for the timely identifi cation of defects such as a loose blade, blade
installed upside down, blade damage or damaged or excessively worn out parts.
Likewise, regularly check that the protective covers or protective elements are not damaged and that they are
in their place.
Before every use of the machine, perform all necessary repairs and maintenance.
In the event that despite regular maintenance the machine does not work, please contact our customer
service, the potential repair should be carried out by our contractual partner in one of the specialised
workshops of the Fieldmann brand.
8.1 BLADE REPLACEMENT
For this task, we recommend that you contact an authorised service centre.
Always use original spare parts.
Before inspecting the blade, always disconnect the lawnmower from the electricity grid
and check that the motor is turned off.
CAUTION
: Remember that the blade still rotates several seconds after the motor is turned off. Never
attempt to stop the blade. In regular intervals, check that the blade is securely fastened, in good condition
and sharp. If necessary, sharpen or replace it.
In the event that the blade hits an object while mowing, turn the lawnmower off and wait until the blade comes to
a stop. Then check the condition of the blade and its fastening bolts.
If these are damaged or if they have been lost then they must be replaced without delay.
Important: While working use protective gloves.
Loosen the two bolts that hold the blade (6 mm Allen key) by turning anticlockwise, remove the blade and
replace it with a new one. Check that the new blade is installed in the correct direction. Tighten the plastic nut of
the fastening bolt turning clockwise.