EN
CORDLESS SCREWDRIVER WITH FLASHLIGHT
USER’S MANUAL
Maintenance and storage
13
6. MAINTENANCE AND STORAGE
Maintenance
WARNING!
It is recommended that all the repair or replacement for this tool shall be performed by a qualifi ed service
technician. Contact or visit the nearest Menards store for more information.
WARNING!
Always use only a soft, dry cloth to clean your screwdriver, never use any detergent or
alcohol.
Disconnect the power unit from the main supply before cleaning.
CAUTION!
No chemical agents are approved for use in cleaning this power tool. Clean with a dry
cloth or towel only.
ATTENTION!
Disconnect the charger if you will not be using it for a long time, if you are changing the
tool or performing maintenance on the tool.
This tool does not require any special maintenance. The same applies to the electrical parts of the tool.
Check whether the device is showing signs of wear.
If the charger is damaged (cover, conductors or connector), immediately arrange its replacement at the
vendors service centre.
Regular care for the machine will ensure not only a long lifetime and performance.
Before use always visually check for worn or damaged parts.
Replace damaged or worn parts. To ensure that the machine always remains balanced, always replace the
entire set of the worn or damaged tools.
Worn or damaged machine parts may only be replaced at an authorised service centre or the vendor.
Before cleaning disconnect this product from the power source.
To clean the plastic parts of the product, use a soft cloth dipped in lukewarm water. Do not use aggressive
cleaning products and solvents as this could damage the surface of the appliance.
Do not clean the machine under running water or submerge under water.
After changing the working tool, check that the working tool is secured in its storage position.
Do not use working tools that are not proportioned for placement into the tang in the magazine.
Do not overload the electric power tool. Use the right type of electric power tool for your work. When the
correct electric power tool is used, the work result will be performed better and more safety.
If it is not possible to turn the main trigger switch on or off, do not work with the tool. All electric power tools
with a trigger switch that do not work are dangerous and must be repaired.
If you are not working with the tool, store it out of the reach of children and prevent persons not informed
about the operation of the tool or this user’s manual to work with the tool. An electric power tool in the hands
of an unqualifi ed person is dangerous.
Perform maintenance on the tool. Check for deviation or blockage of the moving parts, damage of individual
parts and other factors which could affect the operation of the tool. If the tool is damaged, have it repaired
