)'3(
16
EN
Operation | Machine care | Warranty
Check the carbon brushes regularly (dirty or worn carbon brushes result in excessive
sparking and speed faults).
Always replace the carbon brushes in pairs.
8. MACHINE CARE
Overload
Never use excessive force when cutting. Too much pressure reduces the speed of the machine,
and the required power is greatly reduced. This may result in overload which can damage the
motor of the machine. When the machine becomes too hot, allow it to run for two minutes at
no load and then interrupt working for a short time. Clean the machine with a clean cloth and a
brush. Ensure that the ventilation slots are not blocked.
9. WARRANTY
The Warranty Card shall be valid only when submitted together with the purchase receipt.
Keep the both documents in a safe place. To lodge a warranty complaint, turn to your dealer
or a service centre. The warranty shall apply to all product defects and faults that occurred
during the warranty period and were demonstrably attributable to material or manufacturing
defects. In such cases the product shall be repaired and/or adjusted. The warranty shall not
apply to standard wear of the product, as well as to faults attributable to overloading, using of
inappropriate accessories or improper operation of the product.
Summary of Contents for FDP 200711-E
Page 1: ... 1 ...
Page 2: ...3 1 1 2 3 4 5 6 7 8 9 10 11 12 ...
Page 3: ... 3 4 ...
Page 19: ... 3 20 ...
