Fieldmann FDK 201301-E, Instruction Manual

Page: 24 / 25

EN
ELECTRICAL CIRCULAR SAW OPERATING INSTRUCTIONS
25 Technical data
Troubleshooting
Suspected malfunctions are often due to causes the user can fix themselves. Therefore check the product
using this section .In most
c
ases the pro blem can be solved quickly
.
Only perform the steps described within these instruction s! All further inspection
,m
aintenance and repair
work
m
ust be performed by an authorized service centre or a similarly qualified specialist if you cannot solve
the problem yourself
!
WARNING!
Problem Possible Cause Solution
1. Product does not start 1.1 Not
co
nnected to power supply
1.2 P ower cord
or pl
ug is
de
fective
1.3 Other electrical defect to the
product
1.1 Conn ect to power
s
upply
1.2 Check by a
s
pecialist electrician
1.3 Check by a
s
pecialist electrician
2. Product does not reach
full power
2.1 Extension cord is not suitable
for opera tion with this
p
roduct
.
2.2 Power source
（
e.g
.
generator
）
has
t
oo low voltage
2.3 Air vents are blocked
2.1 U se a proper extension cord
2.2 Co nnect
t
o another power
so
urce
2.3 Clean the
air
vents
3. Unsatisfact ory result 3.1 Disk bit
is dull/da
maged
3.2 Disk bit is not suitable for work
piece m aterial
3.1 Replace with new one
3.2 Use proper drill bit
4. Excessive vibration or
noise
4.1 Disk bit
is dull/da
maged
4.2 Bolts
/nut
s are loose
4.1 Replace with a new one
4.2 Tighten bolts
/nut
s