2
1
1. TECHNICAL DATA
1.1 Introduction
No Till Multi Crop Drill
The purchaser may only make the claims under warranty. When he has complied with the
warranty conditions in the supply contract.
Besides the cases specified in the supply agreement, the warrantee shall in any case
become void:
When the implement is delivered, check that it has not been subjected to damage during
transport and that the accessories are in a perfect condition and complete.
Any claims following the receipt of damaged goods shall be presented in writing within 8
days from the receipt of the goods.
This handbook contains the use and maintenance instructions with a list of spare parts of
No Till Multi Crop Drill.
1.2 Warranty
Compliance with instructions given in this handbook is also important since manufacturer
declines all and every responsibility for damage to persons or property cause by
negligence and failure to comply with these instructions.
Fieldking USA No Till Multi Crop Drill is high performance drill designed to sow seed of
wide variety and size. Due to its precise metering system this is achieved accurately and
economically.
Regular and satisfactory operations together with economic and long lasting use of the
implement depends upon the compliance with instructions given in this book.
1.3 When The Warranty Becomes Void
4. No warranty will be given if the service and greasing is not done on time.
2. When repairs made by the customer without authorization from the manufacturer or
owing to installation of spurious spare parts, the machine is subjected to variations and
the damage can be ascribed to these variations.
1. Check seed boxes, there should not be any metal piece or any hard material capable of
damaging metering system.
1. When the implement has been used beyond the specified power limit like (Tractor Horse
Power)
3. When the user has failed to comply with the instructions in this handbook.
1.4. Usage And Instructions :
3. Before sowing the front and rear disc should be in same horizontal
plane, this leveling of disc can be adjusting the Top Link of tractor.
2. Place the drill on leveled surface to adjust the depth of sowing as
desired. By adjusting the height of side packer roller and we can get
the desired depth of sowing. For the vertical moment of balancing
packer roller a special pin arrangement is provided. By removing pin
we can adjust the height of packer roller. As we lower the wheels depth
decreases and as we lift the wheel the sowing depth increases.
4.
Seed Metering Method :
For desired quantity that is to be sown can be adjusted with the
help of grain index plate that is fixed on the seed box. On the grain index plate there is
equal distance holes. There is lever that is move on the above said holes of index plate. A
we step one hole to right side 22Lbs.- Acre can be decreased as we move lever to the left
side. As we move 1 to 2 No. Seed quantity can be increased by 22Lbs. The above said
quantity is for wheat, corn.
Fig.-1
No Till Multi Crop Drill is relatively simple machine. The proper lubrication of the machine
wherever is needed is highly important if satisfactory performance and long life are to be
ensured1. Oil and grease the all lubricating parts daily before sowing (All wheels, shaft
and grease cup etc.)
2. There is a reel on the seed shaft that is beneath the seed box,
grease this reel also, which is very important for the smooth working
of seeding mechanism.
1.5. Maintenance
4. After regular intervals clean and paint both boxes.
5. To adjust row to row distance of tynes loosen the two ‘’U’’ clamps of
the tyne and set the distance as desired and than tighten the clamps
fully (Fig-6).
3. After sowing but before storing the seed take it to any service station
so that the drill can be cleaned / washed through with the high
pressure water spray. But remember after the spray of water, apply
diesel on both boxes with the help of brush or peace of cloth to prevent the box from
rusting. It is important that the No Till Multi Crop Drill should be parked in covered area and
away from sunlight.
6. Before re-using machine in next sowing season, all moving &
rotating parts should work freely/properly.
Fig.-5
Fig.-6