5-GALLON HYDRAULIC RESERVOIR OWNER’S MANUAL
5-GALLON HYDRAULIC RESERVOIR OWNER’S MANUAL
HYDRAULIC RESERVOIR USE AND CARE
•
Do not modify the Hydraulic Reservoir in any way.
Unauthorized modification may impair the
function and/or safety and could affect the life of the equipment.
•
Always check for damaged or worn out parts before using the Hydraulic Reservoir.
Broken parts
will affect its operation. Replace or repair damaged or worn parts immediately.
•
NEVER USE YOUR HAND TO DETECT LEAKS!
CAUTION:
READ and UNDERSTAND this information completely before using Hydraulic Reservoir. All
operators of this equipment must read and completely understand all safety information and
usage instructions. Failure to comply with this information could result in serious injury to the
operator and bystanders or damage to equipment.
Do Not
attempt to add more hydraulic fluid during operation to extend the hydraulic capacity. Ensure all
components in the hydraulic system are appropriately sized and rated for the application.
Do Not
touch the exterior of the reservoir. It can become hot during operation.
Check the hydraulic system (hoses, tubing, clamps/fittings, pump, and cylinders) carefully
before each use.
Do not operate the hydraulic system with frayed, kinked, cracked, or damaged
hydraulic hoses, fittings, or tubing, or if oily residue is observed on any of the components. High fluid
pressures and temperatures are developed in hydraulic equipment. Hydraulic fluid escaping through a
pinhole sized opening can burn or puncture skin, resulting in wounds that could cause blood poisoning,
infection, disability, gangrene, amputation, or death. Therefore, the following instructions should be
heeded at all times when inspecting or servicing hydraulic equipment.
Always make sure the engine/motor is off before servicing the hydraulic system.
In addition,
disconnect spark plug/power supply and relieve system pressure before changing or adjusting hydraulic
system components such as hoses, tubing, fittings, or other components.
Never remove the hydraulic fill cap while in operation.
Hot oil can escape, causing severe burns.
Allow hydraulic system to cool completely before removing hydraulic oil fill cap.
NEVER check for leaks with your hand.
Leaks can be located by holding a piece of cardboard or
wood (at least two feet long) with your hand at one end and passing the other end over the suspected
area (wear eye protection). Look for discoloration of the cardboard or wood.
If injured by escaping fluid, no matter how small the wound is, see a doctor at once. A typical injection
injury may be a small wound that does not look serious. However, severe infection or reaction can result
if proper medical treatment is not administered immediately by a doctor who is familiar with injection
injuries.
PARTS DIAGRAM:
PARTS LIST:
For replacement parts and technical questions, please call
1-218-943-6290.
WARRANTY
One-year limited parts warranty
BAC Industries
PO BOX 155
Miltona, MN 56354
Made in CHINA
2 of 3
3 of 3
Part#
1
2
3
4
Description
Filler/Breather Cap
Inlet Screen
Tank
3/4’’NPT Drain plug
Qty.
1
1
1
1
Part#
5
6
7
8
Description
Suction Screen
3/4’’NPT Return port
1-1/2’’ NPT Suction port
Plug
Qty.
1
1
1
2
Size:145x210mm
157G
铜版纸
REV 01/01/17
2.09.05.30.688
