page 6
WARNING:
Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or blindness.
Never operate the UV-Aire Air Purifying System out of the plenum
. Avoid touching the glass portion of the lamp with your hands.
Plug the lamp power leads back into the power connection.
8.
(See Figure 10)
Close the access door and install the access door screw.
9.
(See Figure 8)
Plug the power cord back into the wall receptacle or restore
10.
power to the UV-500C.
Use the point of a pen or paper clip to press the reset button
11.
beside the lamp LED. (See Figure 13)
Figure 12
Figure 13
Disconnect the lamp connection, then rotate lamp-mounting knob
3.
counterclockwise and pull the lamp out of the unit.
(See Figures 10 & 11)
Remove lamp carefully by un-plugging the lamp from the lamp-
4.
mounting knob. (See Figure 12)
NOTE:
When replacing the lamp, always wipe off lamp with the
supplied alcohol wipe before installing.
Plug the new lamp onto the lamp-mounting knob. (See Figure 12)
5.
Guide the other end of the lamp through the hole in the UV chamber. (See Figure 11)
6.
Secure the lamp into position by rotating the lamp-mounting knob clockwise.
7.
Figure 11
NOTE:
UV lamps contain a small amount of mercury, like a typical fluorescent lamp. According to the EPA’s
Universal Waste Rule, these types of lamps may be disposed of into household waste. Check with your local
waste management authority for local disposal or recycling requirements.
