5
8. Battery slot
9. Switch startup configuration
Figure (2) LCD Schematic Diagram of UPS LCD models
Installation & use steps
1. After unpacking the UPS, check whether there is any mechanic injury
due to transportation. If the UPS appearance has been serious injured,
further examination is needed.
2. Place the UPS in an well-ventilated dry place; do not block the
ventilation of two UPS sides.
3. The rated input and output of UPS are both 230Vac 50 Hz.
The input is a three-core power cord (P+N+G), the output is a
three-core standard IEC socket, and the UPS case is connected with
ground wire. Please make sure the ground wire is well connected.
4. Plug the UPS input power cord into the mains socket, and plug the other
end into the UPS input socket. Please make sure the neutral wire and
live wire are in accordance with national standards, and the ground wire
should be well connected.
The following is the front schematic diagram of input mains socket:
5. Connect the computer and monitor to the “Computer Sockets” of the
UPS (Output Inverter Protected : AC 230Vac), and connect the printer to
the “Printer Socket” (Output Stabilised only : AC 230Vac).
L
N
