71
K.4 Quick Access to Label Settings
If label printer (TSC or LP50) is selected, follow the below procedures to access quick label settings during
operation.
1.
Enter F1, then press
[Check]
,
2.
Instrument displays number of copy to generate each time. Press
[PF/Set]
or
[MR]
until the preferred
parameter appears then press
[Print/M+]
to save.
3.
Instrument displays label file number (FL1 00 ~ FL1 99) to print in label format group 1. Enter the
preferred file number through numeric then press
[Print/M+]
to confirm.
4.
Instrument displays label file number (FL2 00 ~ FL2 99) to print in label format group 2. Enter the
preferred file number through numeric then press
[Print/M+]
to confirm.
5.
At this point, label settings are completed.
K.5 Repetitive Printout
This instrument supports repetitive output under Manual Print Mode. Press
[Print/M+]
for additional output
copies.
Conditions and criteria as below: -
•
When Auto Accumulation is set to On: Repetitive print is only possible when the actual weight on scale
is equal to the weight value of the 1
st
printout.
•
When Auto Accumulation is set to Off: Repetitive print is possible if minimum output weight set is
matched and when
[Print/M+]
is pressed.
•
Weight value of repetitive output will not change the total accumulation result. Only the weight value
of the 1
st
output will be accumulated to memory.
