QUICK START GUIDE
Fidelis Network® High Capacity Collector
www.fidelissecurity.com
©Fidelis Cybersecurity
9
10. Configure the network parameters for the system and each active network interface.
•
Use the Network Configuration table you prepared earlier.
•
When complete, return to the top menu.
11. When complete, select
OK
to leave Setup.
12. From command line, reboot the system:
sudo /fss/bin/shutdown.pl --user admin –reboot
13. Repeat steps for all appliances being added to the Collector cluster
14. Use the PING command to verify connectivity between the XAs on their SYNC/eth2
interfaces.
8. Cluster Setup
On the Final Collector XA4 Appliance
If you have not completed setup for the XA4 appliances in section 7 above, or you are adding an
XA4 appliance to the Collector, follow these steps:
1. Login via KVM console.
2.
Use these credentials at the login prompt.
You will be required to change the password
immediately:
-
user:
fidelis
-
default password:
fidelispass
2. Change to root using the default password
3. From the command line, run
/bin/bpctl_start
/bin/bypass_util all set_force_bypass off
4. From the command line, run: /FSS/bin/setup
5. Navigate to
Collector Settings
.
6. At the XA4 count, enter the number of XA4 appliances, and select
Ok
.
7. Review the list of IP addresses. Select
Confirm
if these are correct or select
Edit
to correct
them.
