Information present herein has been compiled from sources considered to be dependable and is accurate and reliable to the best of our knowledge and belief but is not guaranteed to be so. Nothing
herein is to be construed as recommending any practice or any product violation of any patent or in violation of any law or regulation. It is the user’s responsibility to determine for himself the suitability
of any material for a specific purpose and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and, since conditions of use
are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us.
© Copyright 2020 Fibre Glast Developments Corporation
Fibre Glast Developments Corporation
385 Carr Drive
Brookville, Ohio 45309
Phone: 800.214.8572
Fax: 937.833.6555
www.fibreglast.com
Troubleshooting
126
Symptom
Fluttering or Spitting
Pattern is arc
Pattern is not evenly spread
The center of the pattern is
too narrow
Pattern width of fan-shape
is not enough
Problems
1. Material level tool low
3. Loose fluid inlet connection
4. Loose or damaged fluid tip/ seat
1. Worn or loose Fluid nozzle
2. Material build up on air cap
1. Material build up on air cap
2. Fluid nozzle dirty or worn
1. Material too thin or not enough
2. Atomization air pressure too high
1. Material too thick
2. Atomization air
Solution
1. Add material into container
3. Tighten
4. Adjust or replace
5. Lubricate and or tighten
1. Tighten or replace fluid nozzle
2. Remove obstructions from holes, but don’t use
metal objects to clean it
1. Clean or replace air cap
2. Clean or replace fluid nozzle
1. Regulate material viscosity
2. Reduce air pressure
1. Regulate material viscosity
