Information present herein has been compiled from sources considered to be dependable and is accurate and reliable to the best of our knowledge and belief but is not guaranteed to be so. Nothing
herein is to be construed as recommending any practice or any product violation of any patent or in violation of any law or regulation. It is the user’s responsibility to determine for himself the suitability
of any material for a specific purpose and to adopt such safety precautions as may be necessary. We make no warranty as to the results to be obtained in using any material and, since conditions of use
are not under our control, we must necessarily disclaim all liability with respect to the use of any material supplied by us.
© Copyright 2020 Fibre Glast Developments Corporation
Fibre Glast Developments Corporation
385 Carr Drive
Brookville, Ohio 45309
Phone: 800.214.8572
Fax: 937.833.6555
www.fibreglast.com
Feed Type
Standard Diameter of Nozzle
Recommended air pressure
Material Capacity
Air Consumption
Compressor Required
Air Connection
126-A
Gravity
2.5 mm
2.5 - 3.5 bar (40 - 80 psi)
.6 Liter (20 ounces)
4.7 - 7.1 cfm
1.5 H.P
1/4 n.p.t.
Important Safety Instructions
1. Certain materials can create toxic vapors, intoxication and serious damage to health. Always wear safety glasses,
gloves and respirator to prevent the toxic vapor hazard, or solvent and gel coat coming into contact with your eyes or
skin.
2. Never use oxygen, combustible or any other bottle gas as a power source to avoid explosion and serious personal
injury.
3. Fluid and solvent can be highly flammable or combustible. Use in wellventilated spray booth and avoid any ignition
sources, such as smoking, open flames and sparks.
4. Disconnect tool from air supply when not in use or maintaining also a shut off valve. As an emergency stop is
recommend.
5. Use clean, dry and regulated compressed air rated at 2.0-3.5 bar, (40-80PSI). Never exceed maximum permissive
operating pressure.
6. Never use homogenate hydrocarbon solvent, which can chemically react with aluminum and zinc parts and
chemically compatible with aluminum and zinc parts.
7. Never point gun at you or others at any time.
8. Before operating the tool, make sure all the screws & caps are securely tightened in case of leaking.
9. Before spraying, be sure the trigger and related parts operate smoothly.
10. Never modify this tool for any applications. Only use recommended parts, nozzles and accessories.
Features
126
