http://www.fiberstars.com
79-15053-00 REV. C
Page 14 of 16
Receiver
screws
Face Plate
Molex Connector
Mounting
Screws
Receiver Mounting
Holes
DIP switch
DIP Switch
Rear screws
If it is necessary to change the transmission code on the WPC-1 an adjustment to the receiver AND the transmitter
DIP switches must be performed.
RECEIVER DIP SWITCHES – Turn OFF power to the WPC-1 from the breaker panel. Open the enclosure and
unscrew the face plate. Disconnect the Molex connector that connects the front panel controls to the receiver unit
and set the face plate on a safe location where it will not be bent, scratched, or impact forces applied to the
components or the face plate itself. Unscrew the four (4) screws holding the receiver to the base of the WPC-1
control box. Unscrew the four (4) screws located on the back of the receiver to release the cover. NOTE: Take
notice of how the wires enter and exit the receiver. Remove the cover and look on the PCB to locate the DIP switch
as illustrated.
TRANSMITTER DIP SWITCHES – Remove all screws from rear of remote. Separate the bottom cover from the
top cover.
DIP SWITCH ADJUSTMENT – The four DIP switches have an ON and an OFF position. Changing just one DIP
switch will change the code. MAKE SURE BOTH THE RECEIVER AND TRANSMITTER HAVE THE SAME
DIP SWITCH SETTINGS.
CODE ADJUSTMENTS