www.fiberstars.com
3
IMPORTANT NOTICE
Note: DO NOT INSTALL THE BUBBLER TIP MORE THAN 4 INCHES ABOVE
THE SURFACE AREA. THE INTERIOR OPTIC ROD IS 4 ¾” DOWN FROM THE
TIP’S TOP AND WILL BE DAMAGED IF TRIMMED FOR FLUSH
INSTALLATIONS BELOW THIS LEVEL.
The Lighted Bubbler is designed so that the tip of the bubbler is approximately 5 to 8
inches underwater but can be deeper as long as the water supply volume can be increased.
Keep in mind that the deeper the tip is underwater the less the lighting effect will be
above the water.
Fiberstars recommends that during installation the Lighted Bubbler tip is capped off with
tape, etc. so that no debris gets into the internal area of the bubbler.
The Lighted Bubbler may be installed in many different methods and applications, such
as:
a. Flush with interior surface (described above)
b. Raised off the surface area but with the tip under the water surface – typically
fountains
c. Raised above the water surface – typically fountains
After connecting the fiber to the illuminator and the completion of all steps indicated
above, turn on the water supply.
Adjust the water volume to achieve the desired water flume/lighting effect.
IMPORTANT:
Make sure that the conduit for the fiber when it terminates in the
Fiberstars illuminator is
ABOVE
water level. If not, there is a possibility that the pool
water will siphon from the pool to the illuminator.
For additional questions please contact Fiberstars Customer Service Pool & Spa Division.