FiberHome HG6543C, Product Manual

Page: 76 / 104

HG6543C Product Manual
2. Configure the parameters relevant to QoS according to the requirement. For
details of the parameters, see Table 3-21.
3. Click Apply to save and apply the configuration.
Table 3-21 Parameters of Route QoS Configuration
Item Description
Type Select the priority type. The default setting is DSCP.
Priority
Sets the priority value. The value range for the DSCP priority is 0 to 63;
and that for the 802.1p priority is 0 to 7.
Protocol
The protocol types include ALL, TCP and UDP.
Source IP The source IP address.
Source Port
The source port.
Target IP
The destination IP address.
Target Port The destination port.
Enable Enables or disables the QoS rule.
3.4.4 3.4.4 ACL Configuration
You can configure the access control list (ACL) to filter designated data packets
according to the matching rules. After the ACL rule is enabled, the corresponding
port will filter the packets as per the configured ACL rules.
1. Select Security in the navigation bar and select ACL Settings → ACL Settings
in the left link bar to open the ACL configuration page, as shown in Figure 3-35.
Figure 3-35 ACL Configuration
64 Version: A