3 Product Installation
Version: A
3-3
Fix the network cable and then make Ethernet connectors for both
ends.
Connect Ethernet connector of one end to a certain AN5506-04-A
LAN interface.
Connect Ethernet connector of the other end to an Ethernet
interface on a PC or a switch.
The connection of the network cable is finished.
Note 1: Transmission distance of the network cable is less
than 100m. Therefore the length of the network cable
prepared by the subscriber should not exceed 100m.
Note 2: The AN5506-04-A Ethernet interface supports
MDI/MDIX self-adaption. Either straight-through network cable
or cross-over network cable is suitable for cabling.
3.3.2
Connection of Optical Fiber
The AN5506-04-A adopts wavelength division multiplexing (WDM) mode
and provides “triple-play” integrated access. The connection steps of
optical fibers are as follows.
Plan the wires and cables layout mode of the optical fiber; measure
the distance between the AN5506-04-A PON interface and
upstream optical splitter; select the optical jumper with suitable
length.
Fix the optical fiber; remove the protection covers of the optical
jumper and the AN5506-04-A optical interface.
