Operating Instructions
Hand crimp tool PEW 9.1128
Rev.: 2014-06-02
4 / 5
EN
5 Emergency unlocking
The force lock opens automatically if the crimp procedure completes in full. In case the crimp
procedure needs to be interrupted, the force lock can be released with a suitable tool (e.g.
screwdriver). (figure 7)
4 Application / Crimping prodedure
· Open the tool
· Select the necessary positioner, lift it and turn it in the right position until it locks (figure 2)
· Insert the HFBR connector in the corresponding position (figure 3)
· To avoid turning the HFBR-connector close the tool until the connector is held tightly
· Lift the locking lever and turn until it clicks into place in the upper position (figure 4)
· Insert the prepared wire to the stop and hold tight (figure 5)
· Press the handles together until the compulsory lock is released and the connector has
been crimped
· Tool opens automatically, lift the locking lever and turn downwards, remove the crimped
connector (figure 6)
figure 2
figure 3
figure 4
figure 5
figure 6
figure 7
