7
BASIC ACTIVATIOn
9. Plug the power source into the micro-uSB port if required.
10. Set the main controller in (security/non-security) add mode (see
the controller’s manual).
11. Move and hold your hand close to the center of the pad.
12. If the device is battery powered, high pitched beep will signal
exiting the Standby Mode.
13. Loud sound sequence will confirm entering the menu, keep
holding your hand.
14. After hearing two short beeps (green indicator colour), withdraw
the hand and perform swiping up gesture to confirm selection
(two beeps will confirm validity).
15. Wait for the adding process to end.
16. Successful adding will be confirmed by the Z-Wave controller’s
message and 3 short beeps (green visual indicator colour).
Summary of Contents for SWIPE FGGC-001
Page 2: ......
