10
OPERATInG ThE DEVICE
#6: Operating the device
Acoustic and visual indications:
The Swipe is equipped with a buzzer and LED diode, signalling ges-
ture detection, menu position and status of the device.
Validity of every detected gesture or sequence is signalled by:
• 2 short beeps
(GREEn) - gesture/sequence is valid
• Intermittent tone
(GREEn) - smooth control using circular
gesture
• 1 long beep
(RED) - gesture/sequence is invalid
Reset procedure of the Swipe:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted. In order to reset the device:
1. Make sure the device is powered.
2. Choose 3rd menu position (3 short beeps).
3. After few seconds the device will be restarted. not being added
to the Z-Wave network will be signalized with sequence of 2 short
beeps, pause, 1 short beep (RED).
Waking up the device:
The Swipe needs to be woken up to receive information about the
new configuration from the Z-Wave controller, like parameters and
associations. use 1st menu position to wake up the device or click the
button on the back of the device once.
Menu
allows to perform Z-Wave network actions. In order to use the
menu:
1. Move and hold your hand close to the center of the pad.
2. Loud sound sequence will confirm entering the menu, keep
holding your hand.
3. Wait for the buzzer to indicate the desired menu position:
• 1 short beep
(WhITE indicator colour) - wake up the device
• 2 short beeps
(GREEn indicator colour) - learning mode
(adding/removing)
• 3 short beeps
(YELLOW indicator colour) - the device reset
4. To select current position, withdraw the hand and perform swiping
up gesture to confirm selection (two beeps will confirm validity).
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. use
the reset procedure
only if the primary
controller is missing
or inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in "Adding
the device" on page
8.
i
NOTE
Gestures are not in-
dicated by the LED
diode by default. In
order to enable it, set
the value of parame-
ter 3 to 1.
i
NOTE
If the device is battery
powered, high pitch
beep will signalize ex-
iting from the Standby
Mode before entering
the menu.
i
NOTE
Menu can also be
operated using the
service button B (see
"Additional features"
on page 15)
i
Summary of Contents for SWIPE FGGC-001
Page 2: ......
