o
blinds are calibrated.
2.
By default, time of transition between extreme positions is set to 150 (1.5 seconds) in
parameter 152.
3.
Turn slats between extreme positions by holding UP or DOWN switch:
o
If after full cycle a blind starts moving up or down – decrease the value of
parameter 152,
o
If after full cycle the slats do not reach end positions – increase the value of
parameter 152,
4.
Repeat the previous step until satisfactory positioning is achieved.
5.
Test whether the positioning works correctly. Correctly configured slats should not force
the blinds to move up or down.
Roller blind with built-in driver positioning
1.
Make sure:
o
the device is supplied,
o
the momentary switch is connected to S1 and S2 terminals,
o
the device added to the Z-Wave network,
o
parameter 151 is set to 5 or 6.
2.
By default, time of transition between extreme positions is set to 600 (6 seconds) in
parameters 155 and 156.
3.
Move roller blinds between extreme positions by clicking UP or DOWN switch:
o
If roller blind stops before reaching top – increase the value of parameter 155,
o
If roller blind does not stop after reaching top – decrease the value of parameter
155,
o
If roller blind stops before reaching bottom – increase the value of parameter
156,
o
If roller blind does not stop after reaching bottom – decrease value of parameter
156,
4.
Repeat the previous step until satisfactory positioning is achieved.
5.
Test whether the positioning works correctly.
Inclusion/Exclusion
On factory default the device does not belong to any Z-Wave network. The device needs to be
added to an existing wireless network
to communicate with the devices of this network. This
process is called
Inclusion
.
Devices can also be removed from a network. This process is called
Exclusion
. Both processes
are initiated by the primary controller of the Z-Wave network. This controller is turned into
exclusion respective inclusion mode. Inclusion and Exclusion is then performed doing a special
manual action right on the device.
Inclusion
Quickly, triple click the S1 switch.
