8
OPERATInG THE DEVICE
Resetting the Door/Window Sensor 2:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted.
In order to reset the device:
1. Open the cover.
2. Remove the battery.
3. Install the battery while holding both TMP buttons.
4. Visual LED indicator will be flashing slowly for 5 seconds - keep
holding the buttons.
5. Release one button when the LED indicator starts flashing quickly.
6. Click released button once to confirm launching of reset procedure.
7. Wait a few seconds until a long blink of the LED indicator. Do not
remove the battery.
8. Visual LED indicator will blink 5 times quickly to confirm the reset.
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. Use
reset procedure only
if the primary con-
troller is missing or
inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in “Adding/
i
Replacing the battery:
In FIBARO Home Center controller current battery level is displayed
in the interface. If a battery icon turns red, it means the battery needs
replacement.
NOTE
Opening the casing
may result in trigger-
ing an alarm. To avoid
it, remove the asso-
ciations for the 3rd
group.
i
Notification report:
The device uses notification Command Class to report different
events.
notification Type
Event
Home Security
Tampering, product covering
removed
Access Control
Door/window opened
Access Control
Door/window closed
Power Management
Replace battery now
Heat Alarm
Overheat detected, unknown
location
Heat Alarm
Underheat detected, unknown
location
NOTE
Command Class Ba-
sic value is related to
the status of contact
sensor (0x00 - closed,
0xFF - opened, on de-
fault setting of param-
eter 1. “Door/window
state “).
i
