Fiammetta MOMENTUM HS-18MA9401, Assembly & Operating Instructions

Page: 20 / 33

19
LIGHTING PROCEDURE

Lighting the BBQ is easy, but must be done with due care.

Make sure the LPG cylinder is filled.

Make sure that gas is turned on at the cylinder, or that gas is available to the BBQ.

Check that the end of each burner tube is properly located over each valve orifice.

Make sure all gas connections are securely tightened.

Open the hood or side burner lid
MANUAL IGNITION (in case of lighting failure from BBQ ignition)
With the hood or side burner lid open, place a lit match or long stem gas lighter close to the
burner you wish to light. Be cautious of the position of your hand and ensure it remains a
reasonable distance from the burner. Turn the control to the “High” position. The burner should
light. If it fails to light, return the control to the “OFF” position and try again in five minutes.
FLAME THROWER IGNITION OF BBQ BURNERS
The BBQ burners are equipped with automatic ignition. It works by throwing a flame to the side
of the burner to light
. Push the knob in and turn anticlockwise to the high position. You should
hear and feel a click from the knob. Hold the knob in and observe the flame extend towards
the side of the burner. When the burner ignites, release the control knob. If the burner doesn’t
light on the first attempt, return the knob to the “OFF” position and try several more times. If
the burner still does not light, wait a few minutes to allow the gas to disperse before trying
again.
SIDE BURNER IGNITION
The side burner incorporates an electrode next to the side burner. To light the side burner,
simply push the side burner knob in and turn anticlockwise to the high position. You should
hear and feel a click from the knob. When the burner ignites, release the control knob. If the
burner doesn’t light on the first attempt, return the knob to the “OFF” position and try several
more times. If the burner still does not light, wait a few minutes to allow the gas to disperse
before trying again.