Hollow shaft display
EP25L
Date: 13/01/16
file: EP25L_ing.doc
pag 5/6
Adjusting of quota
After the assembling of instrument on the machine and setting of all parameters, to visualize on the display the
correct measure it is necessary to carry out the reset or preset of quota. Position the shaft in a point in which is
known exactly the correct measure that has to be visualized (ex. stroke checking) or measure the value in that
point of axis. Programme parameter
//
with value 3 in the first digit on the right and go out of the
programming. Now press
RESET
and it will appear Preset, press again 2 times
RESET
and set on the
display the correct measure to visualize, confirm with
RESET
and on the display appears the correct measure.
If the adjusting quota is worth to zero instead of the preset is possible use reset, setting value 1 on the first digit
on the right of
//
, this way pressing
RESET
the value on the display will be zeroed.
Now that the instrument is adjusted its necessary re-establish to the wanted value parameter
//
//
//
//
to avoid
accidental reset/preset of quota.
Battery change
The instrument is supplied with 2 batteries type AA of 1,5V (alkaline type) which assures a functioning of about 1
year. When the loading level goes under a certain value, the indicator of flat-battery begins to blink in occasional
way and when it keeps switched on its necessary to change the batteries within a month.
To enter into the battery-holder its necessary to take off the front-cover prising on the two hollows placed on a
side of the instrument. Take off the cover and take out the battery-holder and change the batteries paying
attention to the polarity indicated. Without batteries the instrument switches off: in this phase do not rotate the
hollow shaft to avoid loosing of correct quota. As soon as the batteries are fitted inside, the instrument
switches on with the same value on the display as at the moment of the switching off and if the shaft has not be
moved the value will be correct. In case the shaft is moved during the switching off, to re-establish the correct
measure its necessary to repeat the adjustment proceeding.
Meaning of the symbols on the display
1.
Indicator of flat battery: begins to blink when the level of loading goes under a certain value and when it
keeps switched on its necessary to change the batteries within 1 month.
2.
Indicator of absolute quota
3.
Indicator of relative quota
4
.
Indicator of mm
5.
Indicator of inches
6.
Indicator of degrees
7.
Indicator of positive Offset: indicates that the measure is corrected by a positive offset
8.
Indicator of negative Offset: indicates that the measure is corrected by a negative offset
9.
Indicator of values changing: it blinks during the programming phase
10.
Indicator of origins: indicates that the origin changing mode is opened
11.
Indicator for origin 1
12.
Indicator for origin 2
Erros messages
overfl
: the current quota passed the maximum value that can be visualized (from –999999 to 999999);
error1
: its necessary to adjust again the quota;
notape
: inner failure, contact the technical assistance.
1
2
7 8
10
3
9
6
5
4
11
12
