FGE Elettronica S.p.a
Via C.A. Dalla Chiesa, 10
25017 – Lonato del Garda (BS)
P.I. IT01975940162
Tel: 030 9919700
Fax: 030 9913955
www.fgespa.com
EN
SLM1: Quick Reference – Rev06
Page 6/9
3
Power supply
connection
Make sure that the supply voltage is correct.
Turn off the voltage from the power patch cord.
Connect the power supply wires to the clamp POWER of the control unit.
4
Checks
Verify that all connections have been done and that the cables are placed correctly
into the dedicated housings.
2.4
Learning process and field-testing
Once completed the installation process described in the previous paragraph, proceed with the starting
and the configuration of the system:
Step
Operation
Description
1
Power supply test
Connect the main power supply
Briefly press the button
on the panel of the control unit to turn the
system on.
The control unit controls the parts connected. LEDs
blink showing
the headers that are connected (T1, T2, T3).
All the installed doors make a short synchronization movement, then every
panel closes completely.
Verify that all panels are closed correctly.
The control unit signals that the status of the system is ready (led Rdy on).
If the learning process has never been made, all the LEDs are on.
2
Execution of the
learning process
Press button
on the control unit panel for at least 5s (led SETUP on).
All the automation systems execute the cycle of learning of the door,
starting from the first panel (individually for each panel).
Verify the correct place of the panel once ended the opening and closing
processes.
At the end of the learning process the panels are all closed.
The speed profiles are pre-set. To change the applied speed profiles, refer to
the User manual.
3
Movements check
through the Inspection
mode of the control
unit
Press button
on the control unit panel for at least 5s.
The Inspection mode of the control unit is now active.
Press-and-hold the button
to open the panels
Press-and-hold the button
to close the panels
Simultaneously press the buttons
and
to select the next panel.
Simultaneously press the buttons
and
to select the previous
panel.
The table below shows the led signals that indicate which door is moving
(LEDs that are not mentioned are OFF):
Summary of Contents for SLM1
Page 19: ...NOTE ...
Page 20: ...NOTE ...
