MR25664
13
MAINTENANCE
GENERAL INFORMATION
Regular maintenance is the key to long equipment life and safe operation. Maintenance
requirements have been reduced to the absolute minimum. However, it is very important that these
maintenance functions be performed as described below.
WARNING!
Failure to obey the following procedures could result in death or serious injury.
•
Never walk under or climb on raised liftarms or a raised attachment.
•
Do not use blocking made of concrete blocks, logs, buckets, barrels or
any other material that cold suddenly collapse or shift positions. Do not
use wood or steel blocking that shows any signs of material decay. Do
not use blocking that is warped, twisted, or tapered.
•
If the attachment must be raised, block the machine with blocks or
jackstands, NOT lift jacks or hoists. Always block the rear wheels of the
Planer in a manner that stabilizes the chassis.
•
Always wear protective equipment including a HARD HAT and EYE
PROTECTION when operating, performing maintenance, or working near
this
product.
•
The Attachment Part group and the Chassis Part group pivot freely. Do
not place any part of your body between these areas or under this
product without stabilizing this pivot point.
MAINTENANCE SCHEDULE
Procedure
Before Each
Use
After Each
Use
Prime Mover
Cylinders - Retract Rods
- Grease threaded & ball ends to prevent rust
Filter, Air, Prime Mover - Clean
Fittings/Hoses, Hydraulic - Check for leaks, Damage
Fittings, Zerk - Grease (See Lubrication Points)
Oil, Hydraulic - Check Level
Hardware - Check for Tightness
Picks
- Check for rotation, flat spots & wear
Safety/Warning Decals - Check for missing or illegible
