10
HOOK-UP OF THE POWER SUPPLY CORD
Make sure that the amplifier is switched off. Connect the power cord to the IEC
socket on the rear panel of the amplifier.
The amplifier is designed to operate at a rated voltage of 230V / 50Hz. Connecting
the device to a mains network with incorrect parameters can lead to damage that is
not covered by manufacturers warranty
HOOK-UP OF THE SIGNAL SOURCES
Connect the signal source to the amplifier inputs IN1, IN2 or IN3. Select the source of
input signal by rotating the input selector located on the front panel of the amplifier.
In order to achieve the highest sound quality, use only high-quality RCA cables. Pay
attention to the proper connection and distinction of the right (R) and the left (L)
channels.
WARNING! To connect a turntable, you need to use an external phono
MC/MM preamplifier or a turntable with a built-in preamplifier.
HOOK-UP OF THE SPEAKERS
Check the impedance of the speaker set that you posses. Connect the speaker cable to
the appropriate terminals on the rear panel of the amplifier. Connect the common
return (black) lead to the amplifier speaker terminal labeled "0". Depending on the
impedance of the speakers that you posses, connect the red lead to the terminal
marked either 4Ω or 8Ω. If your speaker impedance is 6Ω - connect the speaker wire
to the terminal 8Ω.
Summary of Contents for Silver Luna
Page 1: ...Silver Luna USER S MANUAL...
