Fetco PEL0101, User Manual

Page: 13 / 26

EN
GL
ISH
Operator security
If you open the tank lifting the lamp, the augers will stop.
Self-diagnostics
Consult the Problem Solving Section.
Configuration memory
All the functioning modes and the regulations set are registered in a non-volatile memory which is
active even without power; therefore, when you switch on the machine, the tank keeps the
configuration it had when you switched it off, a part from the keyboard lock (as already said).
Minimum level signal
All machines are endowed with a probe that detects the product minimum level in the tanks. When the
product is below this level, the light of the lamp starts blinking. If the product level does not change,
the light will stop blinking after a minute.
Alarms functions
First Class Millennium is endowed with a direct signalling of the problems found. When the electronic
board blinks, it indicates that there is an active alarm. To see what alarm is, please press the
button for 1 second. In the “Problem Solving” section, you can see a complete list of all
possible alarms at pag. 30.
If more than one alarm is active, these will be indicated with more messages that appear alternatively.
How to start the production of slush, sherbets or cold drink with First
Class Millennium
Clean the machine.
Remove the covers and put the mix in the tanks.
Warning
! Don’t fill the tank with only water. In case of freezing product switch off the
board until the product will be liquid.
Warning! To prepare the product mix use only drinkable water.
Warning! the temperature of the poured product must not be lower than 10 °C in order to
allow a correct calibration of the electronic kit that will be indicated as described in the
previous paragraph.
Switch on the main switch (see pic. 7 in appendix-88).
Switch on the auger switch . The following screen will be displayed:
Press the
button to select “slush” or “cold drink”.
Motor On
Press < <> >