Go to fetco.com for the latest versions of all information
Page 7
CBS-7000
Series Brewers & Dispensers
P186 JANUARY 2020
Operating Procedures
Brewing System
Before brewing, always verify the cleanliness of the brew baskets and dispensers.
1. Push the POWER switch to the ON position
•
The button will illuminate to indicate that the brewer has power and is operational.
2. Prepare the brew basket(s).
•
Carefully pull open the drawer holding the brew basket.
•
Grasp the brew basket by one handle, and turn it until you can reach both
handles comfortably.
•
Grasp both handles and lift the basket out of the drawer. If necessary,
empty and rinse the brew basket.
•
Place a paper filter in each basket to be used. Pour the appropriate
amount of pre-measured, ground coffee into the filter. Spread the coffee
evenly in the basket until it is a uniform depth. (The amount of coffee used
will depend on your personal tastes and the recommendation of your
coffee supplier.)
•
Place the brew basket back into the drawer. Turn the brew basket to align either one of the handles
with either front corner of the drawer.
•
Close the drawer completely. When fully closed, it will be flush with the front surface of the brewer.
3. Place the appropriate dispenser(s) in position under the brew baskets.
•
Ensure that the brew-through cover is in place, the dispenser is empty enough to handle the amount of
coffee to be brewed, and the faucets are closed.
•
Ensure that the dispensers are pushed all the way in, and that the brew funnels are aligned with the
bottom of the brew baskets.
•
When using carts, always set both parking brakes by pressing your foot on the paddle just above each
of the two wheels closest to you. When the brakes are set, a green button extends above the paddle.
To release the brakes for moving, press the green button with your foot.
4. When the READY light is on, press the BREW button to start the brew cycle
•
The brew cycle will begin immediately, and the
BREW
button will illuminate. The brew cycle cannot be
started unless the
READY
light is on.
•
Drip delay:
When the brew cycle is finished, the
BREW
button will flash during the drip delay cycle,
indicating that coffee may still be dripping from the bottom of the brew basket.
Optional BREW WAIT setting (See Programming section)
•
If the BREW WAIT setting is ON, and the
READY
light is off when the brew button is pressed, the
BREW
and
READY
lights will begin flashing. When the water has heated to the proper temperature,
the
READY
light will go on, the brew cycle will begin, and the
BREW
button will illuminate with a steady
glow.
•
If necessary, you may stop the brew cycle at any time by pressing the
STOP
button. This will reset the
brewer, and you will have to start a new brew cycle from the beginning.
.
CAUTION:
•
Do not remove the brew basket or move the dispensers immediately after the brew cycle has
finished. Wait until dripping from the bottom of the brew basket has stopped. This may take
several minutes.
•
When removing the brew basket, carefully inspect the inside of the basket for hot coffee that
may have been trapped or has not finished draining.
•
Always set both parking brakes whenever carts are not being transported.
