Fetco CBS-11H, User Manual

Page: 10 / 20

10
Mechanical Illustration - Dispense System
STOP
BREW
SIDE (SECTION) VIEW FRONT VIEW
BREW BASKET
CONTROL PANEL
HOT WATER TANK
DISPENSE TUBE
SPRAY HEAD
BY-PASS TUBE
FLOW DISC
SPRAY CUTTER
LOCKNUT
BY-PASS VALVE
DISPENSE LATCH ASSEMBLY:
SOLENOID ASSY, PUSH ROD, MICROSWITCH,
SOLENOID LATCH PLATE ASSY
WATER LEVEL PROBE
BREW START/STOP HANDLE
BREW START/STOP
HANDLE RETURN
SPRING
DISPENSE FITTING ASSY:
DISPENSE FITTING
DISPENSE FITTING LOCKNUT
SEAL
SEAL LOCKNUT
TEFLON SEAL
SEAL LOCKNUT
TEFLON SEAL
SPRAY HEAD
DRIVE SCREW
DISPENSE TUBE SHAFT
DISPENSE TUBE
To remove the dispense tube:
1. Unscrew seal locknut and
release the drive screw from
dispense tube shaft.
2. Turn the dispense tube
slightly back and forth, while
pushing the tube into the hot
water tank until it is free from
the sprayhead.
Pull the dispense tube out of
the tank. Remember the tube
is bent inside the tank. The
seal will come out with the
tube.
To install the dispense tube:
1. Clean any lime build up off
the tube and then slide the seal
off. Push the seal carefully
into its chamber in the
fitting.(spring towards the hot
water tank.)
2. Place the seal locknut onto
the tube and slide the tube into
the seal. Tighten the seal
locknut.
3. Work the tube back into
the sprayhead seal.
4. Join the dispense tube
shaft and the brew handle
shaft with the drive screw.