Festool Trion PS 300 EQ, Original Instructions Manual

Page: 15 / 93

Wear suitable personal protective equip­
ment: Ear protection, protective goggles,
dust mask for work that generates dust,
protective gloves for working with rough
materials and for changing tools.
– Always connect the machine to a dust ex­
tractor when performing work that gener­
ates dust.
– Check the plug and the cable regularly and
should either become damaged, in order to
avoid a hazard, have them replaced by an
authorised after-sales service workshop.
–
Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
2.3 Metal processing
When processing metal, the following
measures must be taken for safety rea­
sons:
–
Install an upstream residual-current circuit
breaker (RCD, PRCD).
– Connect the machine to a suitable dust ex­
tractor.
– Regularly remove dust deposits from the
motor housing.
– Use a metal saw blade.
– Close the chip guard.
Wear protective goggles.
2.4 Emission levels
The levels determined in accordance
with EN 62841 are typically:
Sound pressure level L
PA
= 83 dB(A)
Sound power level L
WA
= 94 dB(A)
Uncertainty K = 3 dB
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
Vibration emission level a
h
(vector sum for
three directions) and uncertainty K measured in
accordance with EN 62841:
Sawing wood
a
h
= 5.5 m/s 2
K=2.0 m/s 2
Sawing metal
a
h
= 4.5 m/s 2
K = 2.0 m/s
2
The specified emission levels (vibration, noise)
–
are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise
load during operation.
– They represent the primary applications of
the power tool.
CAUTION
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
cycle must be evaluated.
► Depending on the actual load, suitable pro­
tective measures must be defined in order
to protect the operator.
3 Intended use
Jigsaws are designed for sawing wood and ma­
terials similar to wood. With the special saw
blades offered by Festool, these machines can
also be used for sawing plastic, steel, alumini­
um, non-ferrous metal and ceramic plates.
The user is liable for improper or non-in­
tended use.
4 Technical data
Jigsaws PS 300 EQ, PSB 300 EQ
Power 720 W
Stroke rate
1000 - 2900 min -1
Stroke length 26 mm
Pendulum stroke 3 settings
English
15