Festool MX 1200 E EF, Instruction Manual

Page: 10 / 36

10
CAUTION
Inhaling the dust may damage the respiratory
tract.
 When working with dust, you must wear res-
piratory protection.

The network voltage must conform to the voltage
indicated on the rating plate. A 16 A safety use (for
120 V) or a corresponding protective circuit-breaker
is required.
Tightening the stirrer [2]

Screw in the stirrer [2-3] with endpiece M14x2
(wrench size 22) by turning it to the right in the
adapter ErgoFix
[2-1]
(wrench size 19) and use
the wrench to tighten it.
 Fasten the ErgoFix adapter to the stirrer bar,
then insert the assembled stirrer into the slot
of the spindle.
To set-up the working height see chapter Tool set-
tings.
Switching the machine on and off [3]
Always hold the machine with both hands.
Pressing the switch [3-2] puts the machine into op-
eration and taking your hand away from the switch
stops the machine from working.
Using the switch button to control the speed (ac-
celeration function switch).
You can use the switch
[3-2]
to change the level of
the speed until it reaches the speed range that is
set by the speed controller.
Continuous operation
By pressing the switch [3-2] as far as it goes and
pressing the locking switch button [3-1] at the
same time, you can activate continuous operation.
Press and release the switch button
[3-2]
again to
switch off continuous operation.
Temperature-depend-
ent overload protection
This machine is equipped with “cooling mode”
which protects the machine from overheating. If the
machine is under load and overheats, it may shut
down and enter the cooling mode. It is possible to
run the machine, without load, at a reduced speed
in the cooling mode which may reduce the cooling
2-1
2-2
2-3
2
3
3-1 3-2