DRC 18/4 Li
15
GB
8
Tool holder, attachments
Prior to initial use:
apply multi-purpose grease
to the drill spindle and gearbox neck.
8.1
CENTROTEC tool chuck [6]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2
Chuck [7]
For clamping drill bits and bits with max. shaft di-
ameter of 13 mm.
Clamp tool centrally in the chuck.
8.3Angle attachment [8]
Drilling and screwdriving at right angle to machine
(partly as an accessory).
8.4
Tool holder in the drill spindle [9]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
8.5
Depth stop [10]
The depth stop (partly as an accessory) allows the
user to insert screws to a predefined depth. You can
set the dimension by which the screw head pro-
trudes above or is recessed below the surface of the
workpiece.
Depth setting
Turn the housing
[10-1]
to set
the desired fastening depth.
Each detent position changes the
fastening depth by 0.1 mm.
Sleeve A/B must be removed before a screw can be
unscrewed.
9
Working with the machine
9.1
On/Off switch [1-4]
Press = ON, release = OFF
The speed of the machine depends on how far
the on/off switch is pressed in.
9.2
Bit store [1-3]
Magnetic, for storing bits and bit holders.
9.3
Belt clip [1-9]
The belt clip (right/left) allows the user to attach
the machine briefly to work clothing.
9.4
Attaching the additional handle[5]
Always use the additional handle.
Position the additional handle
[5-2]
on the ex-
tension of the gearbox housing and engage the
recesses on the additional handle in the lugs on
the housing.
Turn the handle until secured in position.
Turn the handle to adjust the position in 30° in-
crements.
The drilling depth can be adjusted using the
depth stop
[5-1]
.
9.5
Acoustic warning signal
Acoustic warning signals sound and the machine
switches off in the following operating states:
10
Service and maintenance
WARNING
Risk of injury
Always disconnect the battery pack before per-
forming any type of work on the machine!
CAUTION
Hot and sharp tools
Risk of injury
Do not use insert tools that are blunt or defec-
tive.
Wear protective gloves.
WARNING
Risk of injury
Always secure the workpiece in such a manner
that it cannot move while being machined.
– Preset torque reached.
– "Block protect", starting torque too high.
– Machine overloaded
WARNING
Risk of injury, electric shock
Always disconnect the battery pack from the
machine before any maintenance or care work!
All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
