DRC 18/4 Li
13
GB
– Protect the battery pack from excessive heat > 50
°C or constant heat sources such as sunlight or
naked flames!
– Never use water to extinguish burning li-ion bat-
tery packs! Use sand or a fire blanket.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
– Always pull the mains plug out of the socket
when the charger is not in use.
–
Only for AS/NZS:
The tool shall always be sup-
plied via residual current device with a rated re-
sidual current of 30 mA or less.
2.4
Emission levels
Levels determined in accordance with EN 60745 are
typically:
Vibration emission value a
h
(vector sum for three
directions) and uncertainty K measured in accor-
dance with EN 60745:
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
3
Intended use
Cordless drill suitable for
– drilling in metal, wood, plastic and similar mate-
rials,
– inserting and tightening screws
Charger TCL 3
suitable for
– charging Festool battery packs: BP, BPS and
BPC (NiMH, NiCd, li-ion are recognised automat-
ically.)
– indoor use only.
The user is liable for improper or non-in-
tended use; this also includes continuous in-
dustrial operation.
4
Technical data
* Speed specifications with fully charged battery
pack.
** The maximum speed is reduced in the lower
torque stages.
Further technical data on the charger and bat-
tery packs can be found on page 5.
5
Machine features
Sound pressure level
L
PA
= 73 dB(A)
Sound power level
L
WA
= 84 dB(A)
Uncertainty
K = 3 dB
Wear ear protection.
Drilling in metal
a
h
= 5,6 m/s
2
K = 1,5 m/s
2
Fastening
a
h
< 2,5 m/s
2
K = 1,5 m/s
2
Cordless drill
DRC18/4 Li
Motor voltage
18 V
Idling speed*
1st gear
0 - 400 rpm
2nd gear
0 - 850 rpm
3rd gear
0 - 1850 rpm
4th gear
0 - 3800 rpm
Torque for easy/tough fastening
applications
28/50 Nm
Adjustable torque**
1st gear
0,75 - 12 Nm
2nd gear
0,6 - 7,5 Nm
3rd gear
0,55 - 5 Nm
4th gear
0,5 - 2,7 Nm
Chuck clamping range
1,5 - 13 mm
Drill diameter max.
Wood
50 mm
Metal
12 mm
Fastening in pine
max.
10 mm
Tool holder in drill spindle
1/4"
Weight without battery pack with
Centrotec
1,9 kg
[1-1]
LED light switch
[1-2]
LED lamp
[1-3]
Bit store
[1-4]
On/Off switch
[1-5]
Clamping sleeve
[1-6]
Gear switch
[1-7]
Torque thumbwheel
[1-8]
Right/left switch
[1-9]
Belt clip
[1-10]
Button for releasing the battery pack
