Festool CLEANTEC CTLC MIDI I, Original Instructions Manual

Page: 20 / 24

The cordless mobile dust extractor can be
connected to as many as five remote con­
trols at the same time. The cordless mo­
bile dust extractor can only be connected
to one battery-powered power tool at a
time.
If a cordless mobile dust extractor which
was initially switched on using the battery
pack is switched off using the remote con­
trol, the temporary connection between
the connected battery pack and the cord­
less mobile dust extractor will be lost. The
battery pack can then be connected again.
► Hold down the connection button [1-16] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-17] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Press the MAN button [1-21] on the remote
control.
The remote control is permanently stored in the
cordless mobile dust extractor.
Resetting on the remote control
Resetting deletes the connection between a re­
mote control and the cordless mobile dust ex­
tractor.
► Press and hold the connection button [1-19]
and the MAN button [1-21] for 10 seconds.
The LED indicator [1-20] lights up purple, if the
reset has taken place.
9.3
Connecting a mobile device
The cordless mobile dust extractor can be con­
nected to a mobile device (e.g. for a software
update) using the Festool Work app.
► Hold down the connection button [1-16] on
the cordless mobile dust extractor for three
seconds in standby mode.
The connection display [1-17] rapidly flashes
blue. For a period of 60 seconds, the cordless
mobile dust extractor is ready for connection.
► Follow the instructions provided in the
Festool Work app to authorise the secure
connection.
10 Settings
10.1 Adjusting the suction power
► Press the plus or minus button for the suc­
tion power adjustment [1-14] while extract­
ing.
The green LEDs on the status display [1-15] in­
dicate the current performance level.
10.2 Connecting sleeve
The bypass function of the connecting
sleeve [3-1] prevents strong suction from
sanding machines and floor nozzles on smooth
surfaces.
Open
► Turn the adjusting ring to the "OPEN" posi­
tion.
Close
► Turn the adjusting ring to the "CLOSE" posi­
tion.
10.3 Volumetric flow monitoring (only for
dust class M)
CAUTION
Hazardous dust
Damage to the respiratory passage
► Correct functioning of volumetric flow
monitoring is only ensured with the suction
hose D 27/32x3.5m-AS/CTR.
For safety reasons, an acoustic warning signal
sounds if the air speed in the suction hose falls
below 20 m/s.
Possible causes Solution
Filter bag full. Insert a new filter bag
(see section 11.5 ).
Dirty main filter. Clean the main filter
(see section 11.4 ).
Change the main filter
(see section 11.6 ).
Suction hose is
blocked or kinked.
Eliminate the block or
straighten the hose.
Value set on the
suction power ad­
justment [1-14] is
too low.
Set the suction power
to a higher value (see
section 10.1 ).
Battery charge level
low.
– Charge the battery
packs.
– Use new battery
packs.
Electronic monitor­
ing malfunction.
Have the fault rectified
by a Festool service
workshop.
Working with sand­
ers.
Activate the bypass
function (see sec­
tion 10.2 ).
English
20