10.4 Temperature cut-out
To protect against overheating, the tempera
ture cut-out switches off the cordless mobile
dust extractor before it reaches the critical
temperature. The status display LED [1-15] in
dicates a fault.
LED lights up red
Excessive temperature
► Switch off the cordless mobile dust extrac
tor, let it cool down.
► Switch the cordless mobile dust extractor
on again after approx. ten minutes.
10.5 SysDoc
WARNING
Risk of injury
► Do not stand on the storage area of the
cordless mobile dust extractor.
CAUTION
Risk of injury
► When transporting, ensure that the T-Loc
is closed.
A Systainer can be fastened to the storage area
of the hose holder [1-3] with the T-Loc
lock [1-4].
10.6 Applying the brake
► Raise the front of the cordless mobile dust
extractor slightly.
► Push down the brake [1-10] until it engages
into position.
► Actuate the release button [1-11] to release
it.
11 Working
11.1 Extracting dry materials
CAUTION
Hazardous dust
Damage to the respiratory passage
► Always use a filter bag!
► Check that the main filter is undamaged
before extracting.
When extracting dust that exceeds the
limit value, only extract from one dust
source (power or compressed-air tool).
Observe the following when extracting dust
generated by operating power tools:
Ensure there is adequate ventilation! Observe
regional regulations!
Limit values: Exhaust air max. 50% of the fresh
air volume
Equation: Room volume V
R
x air renewal rate
L
W
11.2 Extracting wet materials/liquids
Remove the filter bag!
Use a special wet filter.
The dust extraction stops automatically when
the maximum fill level is reached.
The bottom LED [1-15] lights up red.
► Switch off the mobile dust extractor [1-12].
► Open the locking clips [1-7] and remove the
top section of the machine.
► Empty the dirt trap [1-9].
After wet extraction, allow the main filter to dry!
Dry the mobile dust extractor before extracting
dry dust.
CAUTION
Hazardous dust
Damage to the respiratory passage
► After extracting wet materials, remove the
wet filter and replace it with the main filter
for dry materials.
CAUTION
Escaping foam and liquids
► Switch off and empty the machine immedi
ately.
11.3 Exhaust-air outlet
CAUTION
Hazardous dust
Damage to the respiratory passage
► Do not blow off any dust!
The exhaust-air outlet offers the option of di
verting the exhaust air outside a building using
the suction hose.
► Open the grille in front of the exhaust-air
outlet [1-8].
► Insert the suction hose in the exhaust-air
outlet [1-8].
11.4 Cleaning the main filter and filter bag
manually
► In standby mode, press the MAN but
ton [1-13].
► Set the suction power to the maximum set
ting [1-14].
English
21
Summary of Contents for CLEANTEC CTLC MIDI I
Page 3: ...3 1 1 2 2x 2x click 2 3 4a 4b 2 1 ...
Page 5: ...8 9 3 2 1 45 45 ...
