Festo VABA-10S6-X Series, Manual

Page: 110 / 196

3. Digital CPX output modules
3−22
Festo P.BE−CPX−EA−EN en 0804g
3.4 I ns t r uct i o ns o n c o mm issi o nin g
The reaction of the I/O modules can be parameterized.
The table below gives an overview of the parameters.
Further information on parameterizing can be found in the
system manual or in the manual for the bus node.
3.4.1 Parameters of the output modules
M od u l e p a r a mete r s : M o ni t or in g t h e C P X m od u l e
Function no. 4828 + m * 64 + 0 m = module number (0
Ū
47)
Description Monitoring of the possible faults can be activated or deactivated (suppressed)
for each module independently. Active monitoring causes the following:
The fault is:
sent to the CPX bus node
displayed by the module common error LED.
Bit
1
2
Surveillance
Description
Short circuit/overload at the outputs (SCO)
Undervoltage at outputs (V
OUT
)
[Monitor]
[Monitor SCO]
[Monitor Vout]
Values 1 = active (presetting)
0 = inactive [Active]
[Inactive]
Note Monitoring can also be set for the complete CPX terminal
(see System parameter monitoring").
Tab.3/18: Monitoring the CPX module