General installation instructions
•
Connect the SPC200 as remote bus slave to the Interbus.
Coupling as installation remote bus slave is not supported.
•
The SPC200 must be connected non-floating to the Interbus.
- With ready-to-use cables make sure that there is a
contact via the plug connector (metal plug) used.
- Connect the screening of the incoming and continuing
Interbus cables directly to the housing of the metal plug.
•
Use low-impedance earthing or potential equalization cables.
Cables and plugs/sockets
Use the folowing cables and plugs/sockets:
Cable
Plug/socket
Recommendation: Use cables
from Phoenix
e.g. IBS RBC/1/1/length in m *)
Standard cable type
Plug: SUB-D 9-pin
Socket: SUB-D 9-pin
*) Order from: Fa. Phoenix, Postfach 1341, 32819 Blomberg, Germany
En
gl
is
h
SPC200-COM-IBS
0503a
15
