SDE3−...
Festo SDE3−... 0604a English
48
7
Operation
Warning
Excessive internal heat will damage the SDE3−....
S
Avoid high cycle frequencies with large pressure amplitudes.
Otherwise, especially in conjunction with lubricated compressed air, the
maximum permitted temperatures of the materials used will be exceeded.
Reset the SDE3−... to the factory setting
(also if the security code cannot be found)
Note
The current settings will be lost after a reset to the factory setting. If necessary,
make a note of these settings before a reset.
In order to reset the SDE3−... to the factory setting:
1. Switch off the operating voltage.
2. Press all three setting elements simultaneously (UP/DOWN button and EDIT
button) and switch the operating voltage on again.
8
Care and maintenance
S
Switch off the following sources of energy before cleaning:
the operating voltage
the compressed air supply
the vacuum.
S
If necessary, clean the SDE3−... .
Soap suds (max. +60° C), petroleum ether and all non−abrasive cleaning agents are
permitted.
Summary of Contents for SDE3 series
