Festo FSSC-12, Operating Instructions Manual

Page: 18 / 88

Commander
Festo FSSC−12 0410a English
18
1 2
3
4
5
6 7
1
START
IN
: Input for an external transducer
for starting (chapter 8)
2
0−POSITION
IN
: Input for direct group base
position. All external transducers are linked
via and−circuits.
3
END
IN
: Input for an external transducer for
stopping after cycle−end in continuous
cycle pre−select.
4
L
IN
: Input for an external transducer for
resetting (chapter 8)
5
STOP
IN
: Input for an external transducer for
stopping in the cycle (chapter 8)
6
P
IN
: Input for operating pressure
7
NOT AUS (EMERGENCY STOP): Input for an
external EMERGENCY−STOP transducer. If
no signal is applied, or if operating pres
sure falls, the outputs A1 ... A12 of the
Festo FSS−12−C Quickstepper are blocked.
This also applies if an external EMERG
ENCY−STOP impact switch is unlocked.
Fig.2: Connections
The non−labelled connections are the interfaces to the sequence controller. These
are connected to the Festo FSS−12−C Quickstepper in accordance with Fig.3.