5.1.2
Preassembly of coupling
16
17
20
K
Fig. 4: Insert motor-side slip ring
1. Insert slip ring [20] into the slot [K] of the motor-side coupling hub [17].
2. Screw on locking screw [16].
17
C
Fig. 5: Push on the coupling hub, motor side
•
Push coupling hub [17] with the matching drilled hole onto the drive shaft [C].
16
Fig. 6: Align coupling hub, motor side
1. Maintain distance (Y)
2. Tighten motor-side clamping screw [16].
20
L
P
Fig. 7: Insert slip ring axis side
•
Insert slip ring [20] into the slot [L] of the axis-side coupling hub [P].
5.1.3
Coupling alignment
NOTICE
Faulty coupling alignment
If dimension Y is incorrectly adjusted, this will cause increased wear of the
toothed belt and may result in mechanical contact between the toothed belt
pulley and the housing or cover.
• Observe distance.
Adjusting dimension Y is measured on the flat face of the mounted adapter
plate [40] with EAMM-U-...-67A.
Fig. 8: Alignment of coupling hub
EAMM-U-
Y±0.3
[mm]
65-T42-57A
18.8
65-T42-60P
19.8
65-T42-67A
19.8
87-T46-67A
19.3
Tab. 3: Dimension Y
5.1.4
Motor and axis connection
N
17
15
18
19
M
Fig. 9: Mount toothed belt pulley, motor side
1. Place elastomer spider [19] with recess [M] outwards in the toothed belt
pulley [15].
2. Push toothed belt pulley [15] with elastomer spider [19] onto the coupling
hub [17] to the stop.
3. Insert retaining ring [18] into the slot [N] of the coupling hub [17].
6
18
19
C
M
P
Fig. 10: Mount toothed belt pulley, axis-side
1. Place elastomer spider [19] with recess [M] outwards in the toothed belt
pulley [6].
2. Push toothed belt pulley [6] with elastomer spider [19] onto the coupling
hub [P] to the stop.
3. Insert retaining ring [18] into the slot [C] of the coupling hub [P].
1
10
Fig. 11: Mount housing on axis
•
Mount housing [1] on the axis with the screws [10].
With EAMM-U
1
Fig. 12: Position motor - without adapter plate
•
Position motor on housing [1].
Ä
The motor is movable and can be easily tilted.
