EHMB
Festo EHMB 1008a English
25
Mounting to the sides A, B and C is
possible (
Fig.9). Tighten the mounting
screws evenly. The tightening torque is
summarised in the following table.
EHMB−...
20
25
32
Screw (through−hole)
Screw (direct mounting)
M5
M5
M6
M5
M6
Tightening torque
M5
M6
[Nm]
5.9
5.9
9.9
5.9
9.9
Centring sleeve
[mm]
dia. 9x4
Fig.10
For eccentric effective loads in a vertical or sloping position:
Warning
Uncontrolled moving masses can cause in
jury to people or damage to property
(squeezing).
If there is a power failure or the toothed
belt breaks inside the EHMB, the effective
load will slide down.
· Make sure that the EHMB is driven only
by motors with a spring−loaded holding
brake.
· Check whether external safety measures
against damage due to a toothed−belt
break are also necessary (e.g.toothed
latches or moving bolts).
In this way you can prevent the effective
load from sliding down.
Fig.9
(A)
(B)
(C)
Fig.11