Page 3
OvuSense
™
User Manual
Important Notes
The data port on the back of the Reader is for manufacturer
use only. DO NOT attempt to plug in any cables.
Handling
The surface of the Reader and the Sensor cradle should be
regularly wiped with fresh paper tissue to keep it clean.
Care must be taken not to drop the Sensor. If dropped,
check the seal around the centre ring for signs of cracking or
breakage. If found, STOP use of the Sensor immediately. DO
NOT use the Sensor if any damage to the coating occurs, or if
the tail is broken. In all cases of damage, REPLACE the Sensor
with a new one by contacting Service using the address in the
User Assistance Section
on the back page of this manual.
If you lose or damage your Sensor during a cycle, you can
simply place a new Sensor on the Reader, and press the Start
key to activate it. Recordings from the previous Sensor will
remain in the memory of the Reader.
Care must be taken not to drop the OvuSense Reader, or
immerse it in liquids. If this does happen, you should check
the unit is still working: Disconnect from the mains supply.
Then switch it on. If the Reader doesn't start or a warning
message is displayed, contact Service using the address in the
User Assistance Section
on the back page of this manual.
DO NOT clean the Sensor in disinfectants or alcohol, or with
antibacterial or disinfectant wipes.
DO NOT subject your Sensor to temperatures above 50°C (or
122°F), e.g. by boiling or microwaving, as this will damage it.
