10
0°
5°
10°
15°
20°
25
°
30°
35°
40°
45°
14
3
7. Use the 13 mm spanner
15
to loosen the hexagon screw slightly by turning it
anticlockwise.
8. Guide the worktable rod
3
into the opening until it reaches the limit stop as
shown in the illustration.
9. Align the worktable (see section "Attaching worktable to sanding disc") and
tighten the screws.
Before first use
Operation
CAUTION!
Risk of injury!
A damaged device or damaged accessories can lead to injuries.
- Check the device and the accessories (see section "Testing").
CAUTION!
Risk of injury!
The tool bit heats up during operation.
- Do not touch the tool bit until it has cooled down again.
Assembly instruction
20
