51.7cc 2 Stroke Petrol Backpack Blower
AFTER SALES SUPPORT
e-mail: [email protected]
1300 889 028
MODEL: №. SBV521 • 02/2020 • 13177
(toll free)
14
Preparation of the blower prior to use
This Petrol Backpack Blower requires some
assembly prior to use. This includes joining of the
blower tubes (4,5,6,7), and securing the throttle
control handle (8) to the upper blow tube (5).
Setting up for use
WARNING: Blower tube installation affects
both blower balance and performance.
Stop the engine before installing or removing the
blower tubes. Never perform any maintenance or
assembly procedures on this machine while the
engine is running.
Assembling the flexible pipe (4)
1) Place the blower in an upright position on the
ground or on a sturdy work surface (See Fig A1).
2) Loosen the 2 x adjustable clamps on the flexible
pipe (4) using the slot end of the combination
screwdriver (32) by turning the screw on the
clamp in an anti-clockwise direction until they
are loose on each end of the flexible pipe (4) (See
Fig. A2)
3) Insert the larger opening end of the flexible pipe
(4) over the end of the elbow tube (3) to the end
until it hits the raised ridge on the end of the
elbow tube (3) (See Fig. A3)
4) Secure the adjustable clamp on the flexible
pipe (4) using the slot end of the combination
screwdriver (32) by turning the screw on the
clamp in a clockwise direction until it tights. (See
Fig. A4)
5) Before proceeding to add the other tubes for
assembly, the throttle control handle (8) needs to
be assembled onto the upper blow tube (5) first.
Assembly
A1.
A2.
A3.
A4.
