Ferno 35A-ST, User Manual, Page: 8 / 32

© Ferno-Washington, Inc. / 234-3451-03 / September 2016
8
3.2 General Specifications
Most general specifications below are rounded to the nearest
whole number. Metric conversions are calculated before rounding
the Imperial measurements. For more information, contact Ferno
Customer Relations (page 2) or your Ferno distributor.
Ferno reserves the right to change specifications without notice.
CNnsorucoiNn
Tubular aluminum
Whttls
Diameter 5 in./127 mm
Width 1.25 in./32 mm
Wheel Bearings Sealed/greaseless
Btd Surfact (35A, 35A-ST) Aluminum tubes
Btd Surfact (35A+, 35A+ST) Aluminum panels
Htigho
1
Bed Position 8 35 in./883 mm
LNading PNsioiNn 2 32 in./810 mm
Bed Position 7 33 in./834 mm
LNading PNsioiNn 1 28 in./711 mm
Bed Position 6 30 in./772 mm
Bed Position 5 28 in./699 mm
Bed Position 4 24 in./616 mm
Bed Position 3 20 in./521 mm
Bed Position 2 16 in./413 mm
Bed Position 1 (folded) 10 in./257 mm
Ltngoh
Maximum 79 in./2007 mm
Minimum 61 in./1549 mm
Widoh (Ovtrall) 24 in./610 mm
Wtigho
2
35A 74 lb/34 kg
35A-ST 78 lb/35 kg
35A+ 84 lb/38 kg
35A+ST 88 lb/40 kg
Sortngoh oN Wtigho RaoiN
3
35A 6.76 SWR
35A-ST 6.41 SWR
35A+ 5.95 SWR
35A+ST 5.68 SWR
LNad Capacioy 500 lb/227 kg
LNad Capacioy (UK) 35.7 so
Note:
All Ferno® mattresses for emergency medical service use
are heat-sealed.
1
Height measurements are as follows: Loading Position is the
distance from the ground to the bottom of the loading wheel. Bed
Position is the distance from the ground to the patient surface,
measured at the casting in the center of the bed surface.
2
Weight is without mattress, restraints and optional features.
3
Strength to Weight Ratio is the Load Capacity of the cot divided
by the cot’s weight.
3.3 Cot Positions
About the Cot
FOLDED POSITION
Use the folded position to transfer the patient, secure the cot
inside an ambulance, or to store the cot.
Bed Position
ROLLING/TRANSFER POSITION (5)
Use a level position to roll the cot and for transferring the
patient to or from the cot.
Bed Position
Bed Position
LOADING POSITION (2)
The loading positions are for use only when loading the cot
into, or unloading the cot from, an ambulance. Use the lowest
loading position that allows the cot to roll into the ambulance.
Loading Position
Load Capacity
Inspect the cot if the load capacity has
been exceeded. See Inspecting the Cot ,
page 27).
500 lb
227 kg
35.7 st